mxriderx03 wrote:

Then who fix all the bearings for you rezal??

DIY bro...d=)

good experience for me...

Bought clutch plates and gaskets for 70.
Main and pilot jet for 13.

But i do have a question, why did he gave me a gasket for the right engine case when the clutch casing is only like circle shaped?

And also, its not necessary to change the spring also rite during a clutch replacement?

Please assist.

cheers

hi guys, appreciate if you could give the heads up on best price and where's to have the steering cone changed?

hey man, changed my steering cones at mah motor parts $65 - $75 cannot remember.

now changing the balancers of the steering cones.. quoted about $110

broke my kick start.

FJT - $90
LAB - $78

so i bought LAB save $$ but the locking part slightly slightly bigger, now my bike is safe(less likely to be stolen).. i can remove my kick-start after starting bike.. and keep in my backpack..

if i'm not wrong got 2 types of kick starter for different models of XR4.. my 98 XR4 starter cannot use 96 XR4 starter.. last time i change with my friend to try liao..

yeah both told me got 2 sizes, apparently both told me 98 is bigger, so i got the 98 one which looks about the same as my broken one.

anyway i also never double checked if FP plater is 98 or 96.. bought the bike..roughly know when is the coe.. then cannot be bothered.. so it's my ignorance hahah..

anyway will the 96 model kick start much smaller? the 98 diameter is about 2cm or slightly bigger.

EatingClay wrote:

hey man, changed my steering cones at mah motor parts $65 - $75 cannot remember.

Thank dude, so far the price quotes I received was the least at 110, dont remember changing steering cone costing so much, will go down to Jeffery at dunlop and check it out...

Where can i get e canvas strap which is use for the pipe?

Hi guys, do anyone know where can i buy spark plug changing tool for xr400? How much does it cost? I bought 1 from mustafa week ago but it was too long, can't even get the wrech into the plug. Got another wrech at home but was too short. Went to LAB but they do not have it. Hope to get 1 asap just in case i need to change it myself. Thanks....

Just to share,
Bought xr4 rear break pump kit $25. FJT.
Very easy to diy...
was quoted by a few bike shop at $70 for the change.

bigfatlump wrote:

Where can i get e canvas strap which is use for the pipe?

I believe u're looking for this - Exhaust wrap!

Quik-fill fuel cap - $95 at chiong aik desker road


Lockable fuel cap - $35 at chiong aik desker road

bros.. 2qns.

1. how much for new fuelcock?

2. how much to service forks? recommended shop?

kid_rizal wrote:
ENergiZer wrote:
shgrmhjk wrote:
kid_rizal wrote:
sham, where to get the footpegs? abit hard to find ley...

seng fong der have la bro..rm30+/pair if i'm not wrong...

Yeah, whole set (Footrest bracket +footrest+welding) = RM65

joe, sham, thanks bros...got mine done there alrdy...cheap2...good2...

got mine done too ~! cheap cheap and good good



Hi, where u guys did Footrest bracket +footrest+welding? in JB? mind update me specific place? i need for my bike too...

can i just check whether will the rain water seep into my fuel tank if i use a lockable gas cap?