where can i hone my cylinder? change piston ring
how much mm does it remove?

if i exceed the service limit, i go for rebore. i up size my piston, how much size i go
example cylinder 84.10mm my piston wat size? or is there standard size given?

***MOST IMPORTANT***
who got bore gauge or micrometer to lend? i can go over to use. to measure 0.001
ugent

thank you very the much

y my tensioner look like tat in the cylinder?
community.webshots.com...r/shaocong

if u see this post in other forum so sorry coz i in need of help

Hi yammie, sorry can't help u out with micrometer...only got vernier calliper(0.01mm)..

Anyway out off topic. When u removed the top head engine, did u need to position the piston to TDC before u remove it(top)??? I'm thinking of changing the piston ring and timing chain so any advice is appreciated... I think i should be ok to change the rings but 50-50 on the timing chain. And do u have any idea wat parts i should get them ready??? New rings, timing chain, gasket......????

Thanks.

my vernier only till 0.1....or +-0.05
lend me yrs also can haha.

i did positon TDC.
i nv buy anything. i decide to strip 1st dan i go buy. timing chain need to strip RHS case too.